Troubleshooter - Mertik GV60

1.02 Batteries + communication

1. Batteries empty or weak? Replace with 4x AA (alkaline, non-rechargeable).

2. You will hear a short beep after inserting the new batteries.
    (If you do not hear a beep, replace the receiver).

3. You will now set the communication code between transmitter and receiver:

    - Press the RESET button on the receiver until a short and long beep sounds.
    - Release the RESET button and then press (within 20 sec) the 'flame-down' button on the remote control.
    - After this, you will hear 2 beeps and briefly the sound of a running servo motor.
      The communication code has been successfully set.

Do you not hear the 2 beeps and the running servomotor? If so, please contact DRU Customer Service.

! After switching off the fire, the remote control is signal is locked for 120 seconds.
  (60 seconds on older fires)

Hide popup